---
title: Collection of appliable T480 related Mods & Tweaks (included, but not limited to libreboot).
x-toc-enable: true
...


## Disclaimer

Any changes to the hardware or software listed here are usually tested (by atleast one user),
and reproducible **AT YOUR OWN RESPONSIBILITY**.

Some **physical modifications might be *UNREVERSIBLE*, only replacable**,
keep in mind.

In case if you need any help or get another idea to include here,
submit a patch on codeberg or get in contact on irc.


### [Reversible] Improved cpu cooling (t480/s/t580)

Only for boards without nvidia dgpu, as those have the it already.

Simply replace the single-pipe heatsink with a compatible dual-pipe one,
**make sure to isolate the cooler** with a kapton tape or thermal pad **to prevent damaging the board**.

For more silent operation, a Sunon (FRU 01YR202) is advised. Refer to youtube for more.

A great -10 ~ -20 °C difference in operating temperature.


### [Complex] UART Mod (t480/t580)

Before installing Libreboot as [described on the installation page](../docs/install/t480.md),
updating/downgrading to the `n24ur39w` is required, as the EC UART support in coreboot
specifically taps into the EC code of that release. 

The EC on ThinkPad T480 has a UART available, and it is enabled in coreboot,
as used by Libreboot. However, you must use a *specific* EC firmware version.
Please read notes elsewhere in this page regarding Lenovo UEFI/EC BIOS updates;
an exact version number is referenced, which you must install prior to Libreboot
installation.

Ways to flash the EC firmware from Libreboot have not yet been established. Now,
please observe the following photo:

<img tabindex=1 alt="ThinkPad T480 UART jumpers" class="p" src="https://av.libreboot.org/t480/t480uart.jpg" /><span class="f"><img src="https://av.libreboot.org/t480/t480uart.jpg" /></span>

You will solder zero-ohm jumpers on the indicated footprints. These correspond
to TX and RX, which are connected to the R and L lines on the headphone jack,
respectively; a ground will also be available.

You must solder the zero-ohm jumpers, for UART to work. They are *0201* type
jumpers, which are extremely small. Please only do this if you have *excellent*
soldering skills because it's easy to goof this up if you're not careful.

You can hook this up to any 3.3v TTL UART dongle, to get a serial console. The
correct baud rate is 115200.


### [Complex] 3rd NVMe Mod (T480/s/T580) (by Mate Kukri) 

Boards **without the Nvidia graphics**,
the solder pads for all the componentry (including the GPU) is still present,
so you could theoretically design a QSB that solders to the right pads,
and use it to wire a 3rd NVMe SSD;
the port is still enabled in Libreboot even if nothing is plugged into it, so it
should just work. (this doesn't actually exist yet, but it is electrically possible,
quite feasible to design/manufacture and already supported in the Libreboot firmware in principle,
since than PCI-E lane is enabled in the devicetree)

This mod is possible on the T480/s/T580, though on T480s there would be less clearance;
using a smaller internal battery and having a makeshift NVMe caddy in the remaining space,
would be the way about it there.
On the regular T480/t580, the existing caddy area could easily fit two NVMe drives.


[//]: # "SPDX-License-Identifier: GFDL-1.3-or-later"
